26. e Button Cell Battery represents a small
part and a choking hazard – KEEP away from
children!
27. Exercise care in handling batteries in
order not to short out the batteries with
conducting materials such as rings, bracelets and
keys.
28. Overcharging, short circuiting, reverse
charging, mutilation, or incineration of
batteries must be avoided to prevent one or
more of the following occurrences: release of toxic
materials, release of hydrogen and/or oxygen, gas
and rise in surface temperature.
29. DO NOT attempt to recharge batteries
provided with or identified for use with this
product that are not intended to be charged.
e batteries may leak corrosive electrolyte or
explode.
30. Incorrect polarity installation of the
batteries in the end product must be avoided.
Reverse insertion of batteries can cause charging,
and that may result in leakage or explosion.
31. Battery swelling can occur with the type of
battery used in the Parent Unit if not used or
stored correctly including but not limited to the
age, usage pattern, environmental conditions
(over heating), over-charging, over-discharging,
using incorrect chargers and physical abuse/
damage. Refer to Angelcare online Battery Warning
Statement - https://angelcarebaby.com/
battery-safety
32. Remove batteries from units if you store
the product over 30 days because the batteries
could leak and damage the product.
33. Discard ‘dead’ batteries as soon as possible
since ‘dead’ batteries are more likely to leak in a
product. If a battery has leaked or vented, discard
product responsibly.
34. DO NOT store this product, or the
batteries provided with or identified for
use with this product, in high-temperature
& high humidity environments and avoid
direct sunlight – this could lead to potential
battery leakage, swelling and potential harm
and damage. e parent Unit Lithium battery
should be stored at 23±5 °C (73.4 ± 9 °F) at
≤ 75% RH. Always store the product with
approximately 50% charge and do not store
for more than 3 months without charging.
35. CAUTION
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Battery cannot be subjected to high or low extreme
temperatures, low air pressure at high altitude
during use, storage or transportation.
• Replacement of a battery with an incorrect type can
result in an explosion or the leakage of flammable
liquid or gas.
• Disposal of a battery into fire or a hot oven, or
mechanically crushing or cutting of a battery, can
result in an explosion.
• Leaving a battery in an extremely high temperature
surrounding environment can result in an explosion
or the leakage of flammable liquid or gas.
• A battery subjected to extremely low air pressure
may result in an explosion or the leakage of
flammable liquid or gas.
• e applied nameplate is located at the product rear
enclosure.
IMPORTANT SAFETY INSTRUCTIONS
36. Sensor Pad –
• If your cot does not have a solid, stationary,
completely flat, firm surface including a spring or
slat base, place a hard board between the cot base
and the Sensor Pad, to ensure correct operation
(see specification on STEP 2).
• e Sensor Pad functions with standard cot
sprung and foam mattresses and not memory
foam (partial or full), hollow frame construction
mattresses and water beds. Please consult
Angelcare if unsure of mattress compatibility.
37. Only use attachments/accessories
and replacement parts specified by
the manufacturer. Any mounting of the
product should follow the manufacturer’s
instructions.
• DO NOT position this product on an unstable cart,
stand, tripod, bracket or table. e product may
fall, causing serious injury to a child or adult and
serious damage to the product.
• Use ONLY the stand sold with the product.
• Be sure replacement parts are supplied by
Angelcare and have the same characteristics as
original part. Unauthorised substitution may result
in fire, electric shock or fire.
38. Nursery Unit Antenna - e antenna used
for this transmitter must be installed to provide a
separation distance of at least 8’’ (20 cm) from all
persons and must not be collocated or operating in
conjunction with any other antenna or transmitter.
39. Cleaning - Disconnect all units before
cleaning. DO NOT immerse in water any part of the
monitor. Clean only with dry cloth.
28
To Next Page
Loading...
