• If your cot does not have a solid, stationary, completely flat, firm surface including a spring
or slat base, place a hardboard between the cot base and the Sensor Pad, to ensure correct
operation. e hardboard support must measure at least 30 x 30 cm
and 6 mm thick. is hardboard support must be larger than the Sensor
Pad surface area.
• e Sensor Pad functions with standard cot sprung and foam
mattresses and not memory foam (partial or full), hollow frame
construction mattresses and water beds. Please consult Angelcare if
unsure of mattress compatibility. e hardboard maintains a constant
pressure on the Sensor Pad, enabling it to detect the baby’s movements even when the baby
is at the edges of the cot.
IMPORTANT
2 SETTING UP THE NURSERY UNIT
Sensor Pad
Place the
Nursery Unit at
least 1 metre
from the cot.
3 TURNING ON YOUR MONITOR
e Movement Sensor Pad alarm will sound after a few seconds if the child is not in the cot.
Note:
• e Nursery Unit will flash blue to confirm pairing
with the Sensor Pad.
• If the green light does not appear but the red
light is flashing; or if there are false alarms,
adjust the sensitivity level (STEP 3, TEST THE
SENSOR PAD).
30
To Next Page
Loading...
