PAUSING AND RESTARTING THE SENSOR PAD
• Allows you to pause the Sensor Pad if you remove baby from the
cot, e.g. for feeding or comforting. Ensure to un-pause the Sensor
Pad before putting baby in the cot.
TEST THE SENSOR PAD
1. Sources of vibration & movement other than your baby’s can be detected by the Sensor Pad
and interfere with the performance of your Angelcare monitor. e alarm
will not sound if it detects movement other than your baby’s.
2. ere are 3 sensitivity settings – low, medium and high. e unit is set at
medium (default) and can be adjusted accordingly.
3. e Sensor Pad will detect false movements if you are touching the cot.
4. e monitor will produce a Rouse alarm single beep tone designed to stir baby
if no movement has been detected for 15 seconds. If no further movement is
detected, the main alarm will sound at 20 seconds – a series of continuous beeps.
SENSOR PAD FOUR CORNER TEST
1. Place the Sensor Pad at the approximate centre of baby’s sleeping area and put the mattress back in
place.
2. Switch ON the Nursery Unit – check that Nursery Unit and Sensor Pad are paired (connected).
3. Immediately pat your hand lightly and continuously on a corner of the mattress twice for Sensor to
detect movement.
4. Step away from the cot.
5. e alarm will sound from the Nursery and Parent Unit after 20 seconds.
If the Alarm does not sound, ensure everything is setup correctly and try
again; check battery levels on all units, follow the manual for ‘NO ALARMS’
– the sensitivity setting may require lowering by a single level due to other
vibrations/movements.
6. If the alarm sounds, pat your hand lightly on a corner of mattress twice
for Sensor to detect movement. It may take up to 8 seconds to recognise
movement and for alarm to stop.
7. If the alarm continues, even after lightly patting the corner of your mattress twice, adjust the sensitivity
higher and repeat this test.
• Test your monitor before first use.
• Prior to use and on a regular basis (before placing your child in the cot) always check the
Sensor Pad is detecting no movements or vibrations in its environment.
• Test your monitor every time you move the Sensor Pad to a different place.
IMPORTANT
2
E
N
31
To Next Page
Loading...
