6 TROUBLESHOOTING
MOVEMENT SENSOR PAD NO ALARM
• Sources of vibration & movement other than your baby’s can be detected by the Sensor Pad and the alarm will not
sound.
• Refer to Warnings 3 to 10 and see STEP 3, TEST THE SENSOR PAD.
MOVEMENT SENSOR PAD FALSE ALARMS SENSOR PAD LIGHT INDICATOR FLASHING RED
• Sensor Pad False alarms may happen for several reasons, always be sure to immediately check on baby whenever
an alarm sounds:
- Nursery Unit has not been turned OFF after you have removed your baby from the cot.
- Make sure there is no bedding between the mattress and the Sensor Pad.
- Sensor Pad has not been placed under the mattress properly. Be sure the Sensor Pad is on a flat, firm surface with the
printed side facing up.
- e sensitivity level may also need to be adjusted.
LOSS OF CONNECTIVITY NURSERY UNIT BLUE LIGHT FLASHES AND EMITS A BEEP EVERY
20 SECONDS
• Bring the units closer together.
• Press and hold for 2 seconds the Nursery Unit Power ON/OFF button, the Nursery Unit will emit a beep and will flash
blue to confirm connectivity.
NO POWER
• Check or replace batteries.
• Make sure monitor is ON.
E
N
33
To Next Page
Loading...
