Anglecare AC027 - Setup Requirements; Whats in the Box; What You Need

SET UP REQUIREMENTS
WHAT’S IN THE BOX
1
Nursery Unit
2
2 x 1.5V AAA alkaline batteries
(for Nursery Unit)
3
Stand (for Nursery Unit)
4
Sensor Pad
5
CR2450 3V Battery
(for Sensor Pad)
WHAT YOU NEED
• Hardboard, if the cot does not
have a firm surface
(see ‘IMPORTANT’ note - Step 1).
• Posidrive screwdriver
4
5
1
3
1 SETTING UP THE SENSOR PAD
e Sensor Pad is designed to detect subtle baby movements on the surface of the
mattress.e alarm will only sound if NO movement is detected for 20 seconds.
1. Remove the tab from the battery holder.
2. Use a coin to remove/replace the
battery cover and insert the battery
face with + face up.
3. Replace the battery cover, align 2 dots
and click to secure.
4. Remove the mattress from
the cot, place Sensor Pad
- Angelcare® logo side up - on base
in approximate centre of mattress,
along the length. It should be centred
on the hardboard if your cot requires
a hardboard support (see ‘IMPORTANT’
note below).
5. Replace the mattress.
Correct positioning
for slatted base
4
1
2
3
E
N
29