Anglecare AC027 - Getting to Know Your Monitor; Nursery Unit

4 GETTING TO KNOW YOUR MONITOR
NURSERY UNIT
1
Power indicator / Low battery light indicator
2
Movement Sensor Pad indicator
3
Pause movement Sensor Pad
Allows you to pause the Sensor Pad if you remove
baby from the cot, e.g. for feeding or comforting.
Ensure to un-pause the Sensor Pad before
putting baby in the cot.
/ Pairing button
(press & hold)
4
Power ON/OFF (press & hold)
5
Movement Sensor Pad Sensitivity Switch
To ensure adequate monitoring of your child’s
movements, you can adjust the sensitivity of the
Sensor Pad (STEP 3, TEST THE SENSOR PAD).
6
Battery door (2 x AAA)
1
2
6
3
4
5
5 NURSERY UNIT ALERTS
NURSERY UNIT
1
Power ON/OFF & Low Battery Light Indicator
Flashing green: Monitor is activated.
Flashing yellow: Nursery Unit battery is low.
• e Nursery Unit emits a single beep every
20 seconds.
2
Movement Sensor Pad
Flashing red: No movement is detected.
• e Nursery Unit speakers will emit loud consecutive
beeps - this is the Movement Alarm.
Flashing white: Monitor is paused.
Flashing light blue: Loss of connectivity between the
Nursery Unit and the Sensor Pad.
• e Nursery Unit emits a single beep every 20 seconds.
Flashing yellow: Sensor Pad battery is low.
• e Nursery Unit emits a single beep every 20 seconds.
1
2
Note:
Press Pause on the Nursery Unit to stop the alarm.
32