Page 11 of 16
Note: You may use this heat function whilst using the massager in any mode.
Press the On / Off “PWR” button to turn the massager off.
6.3 Intensity “INT” Button:
Note: there are four intensity levels. When the massager is powered On, the
default intensity (strength of massage) is set at Maximum.
Press the “INT” button and the massage intensity will decrease by one step.
Press this button again, and the massage intensity will decrease a second step.
Press this button again, and the massage intensity will decrease a third step.
Press this button again, and the massage intensity will decrease a fourth step.
Press this button again, and the massage intensity will cycle back around to
Maximum intensity.
6.4 Mode Button (5 Modes):
When the On / Off “PWR” button is pressed the Massager will start in default
Mode “Auto” with Maximum Intensity and 15 minute Auto-Off.
The “Auto” and “15 Min” Indicator lights will illuminate.
Description of Mode “Auto”: Auto mode will cycle through All massage Modes
as indicated by the lights within the “Body” diagram illuminating in unison with
the massage motors turning on and/or off.
Press the “Mode” button, and the massager mode will change to “Kneading”
Mode and the corresponding indicator light will illuminate.
The massage “Zone” will be indicated by the lights within the “Body” diagram
illuminating in unison with the massage motors turning on and/or off.
Description of Mode “Kneading: Continuous lifting, rolling & circular motion
through the upper back, middle back, lower back, and thighs.
Press the “Mode” button again, and the massager mode will change to “Pulsate”
Mode and the corresponding indicator light will illuminate.
The massage “Zone” will be indicated by the lights within the “Body” diagram
illuminating in unison with the massage motors turning on and/or off.
Description of Mode “Pulsate: Continuous rhythmical expanding and
contracting throbbing motion through the upper back, middle back, lower back,
and thighs.
To Next Page
Loading...
