EasyManua.ls Logo

anko CF-2602 - Features and Operation; Product Features; Power Supply Setup

anko CF-2602
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 9 of 16
4 Features
Built-in 5 vibration massage motors.
Back Heater.
5 pre-programmed massage modes.
4 levels of vibration intensity.
15, 30 and 60 minute selectable Auto-Off timer.
Convenient Corded Remote controller
5 Operation Procedure
NOTE: This appliance will automatically turn off after approximately 15, 30 or 60
minutes of operation, depending on your selection.
Do Not use for more than 60 minutes at a time without a 60 minute cool down
period in between.
This should not be considered as a substitute for manually turning off your
appliance. Always remember to turn off and unplug when not in use.
5.1 Power supply
Use only with Power Supply Model: ZD012M120100AU
Before first use, please read this Instruction Manual carefully.
Unfold the massager and fit it to an upright chair using the back elastic straps to
secure around the chair.
Insert the small plug end of the power supply into the small socket of the massager
as shown.
Plug the power supply into the power point and switch it on.
The appliance is now ready for use.
Massager
Side
Power Supply
Side

Related product manuals