Please use your TV remote control to switch signal source. If the signal
source is right but you cannot get display, this is typically caused by
resolution compatibility issue.
The default NVR resolution is 1920x1080, please ensure TV resolution is
1920x1080 or bigger, also the video mode is correct.
1. Please use other HDMI or VGA cable connect camera system and
monitor.
2. The monitor's resolution must be higher than the display resolution of
NVR. If not, monitor is not able to show any image of cameras. The NVR
default resolution is 1920x1080. If monitor can't show any image of
cameras, it can prove the display resolution of NVR is higher than your
monitor's, please adjust the resolution of your monitor to 1920x1080 or
use a higher than 1920x1080 resolution monitor to connect NVR.
3. Please change the other monitor connect camera system and use the
computer monitor to connect your system, the TV signal source may not
be compatible.
Q6. What to do if hard disk drive can't be recognized？
A: Please make sure yours does include a pre installed hard drive inside
first.
Go to Main Menu→System→HDD Manage and check if there is hard
drive and its status is Normal.
To Next Page
Loading...