134
3.3.2.5. Minimum Output Power for CA (intra-band contiguous DL CA and UL CA) (6.3.2A.1)
3.3.2.5.1. MT8820C
This measurement item is not supported by the MT8820C.
Refere to Table 3.3–1.
3.3.2.5.2. MT8821C
This subsection describes an example of intra–band measurement.
[Pass/Fail evaluation limits value setting]
1. Execute PWR_AVG 20 to set the average count of Power measurement to 20 times.
2. Execute TP_MINPWR_UL -39.0, PCC to set TX1 – Min. Power Pass/Fail judgment for PCC.
3. Execute TP_MINPWR_UL -39.0, SCC1 to set TX1 – Min. Power Pass/Fail judgment for SCC-1.
[Measurements]
4. Execute TESTPRM TX_MINPWR to set Test Parameter to TX1 – Min. Power.
5. Execute SWP to measure the power.
6. Execute CHPWR? AVG, PCC to read the Channel Power measurement result for PCC.
7. Execute CHPWR? AVG, SCC1 to read the Channel Power measurement result for SCC–1.
8. Execute CHPWRPASS? PCC to check that the Channel Power measurement Pass/Fail judgment for PCC is Pass.
9. Execute CHPWRPASS? SCC-1 to check that the Channel Power measurement Pass/Fail judgment for SCC–1 is
Pass.
10. Execute CHPWRPASS? to check that the Channel Power measurement Pass/Fail judgment for all CCs is Pass.
NOTE 2: Pass/Fail judgment values differ depending on the Carrier Frequency f.
f ≤ 3.0GHz : ≤ –39 dBm (as the initial value)
3.0GHz < f ≤ 4.2GHz : ≤ –38.7 dBm
To Next Page
Loading...
