Anritsu MT8821C - Page 222

222
[Procedure using GUI]
Set each parameter at Common Parameter (PCC/SCC–1/SCC–2), Call Processing Parameter, and Fundamental
Measurement Parameter.
Common Parameter – PCC
1. Execute Preset to set default parameter.
2. Set Common Parameter – Call Processing to On.
3. Set Common Parameter – Frequency – Channel Bandwidth to 20 MHz.
4. Set Common Parameter – Frequency – UL Channel and DL Channel to 18300 and 300, respectively.
5. Set Common Parameter – Signal – Channel Coding to Packet (DL CA).
6. Set Common Parameter – Signal – Antenna Configuration to 2x2MIMO (Open Loop).
7. Set Common Parameter – Signal – UE Category to 9.
(When 4DL CA, Set Common Parameter – Signal - UE Category to 11. )
8. Set Common Parameter – Level – Output Level(Total) to –35.0 dBm.
9. Set Common Parameter – UL RMC – Number of RB to 100.
10. Set Common Parameter – UL RMC – MCS Index to 23.
11. Set Common Parameter – DL RMC – Number of RB to 100, and Common Parameter – DL RMC –
Starting RB to 0.
12. Set All of Common Parameter – DL RMC – MCS Index1/2/3 to 28.