4.3 SOURce Subsystem Commands
4-11
4
OTDR Commands
4.3.8 SOURce:RESo Command
Syntax: SOURce:RESo<wsp><value>
Parameters: <value>
Integer format
Range: 0|1|2, 0-Low Density, 1-High Density, 2-Very High Density
Available resolution values are dependant on current range settings.
Description: Set current resolution.
Example: sour:res 1
Response: None
Errors: (–200, "std_execGen, Test is Active")
(–224, "std_illegalParmValue, Invalid Parameter Value")
4.3.9 SOURce:RESo? Command
Syntax: SOURce:RESo?
Parameters: None
Description: Query current resolution settings flag.
Example: sour:res? --- 1<END>
Response: The value is current resolution: 0-Low Density, 1-High Density, 2-Very High
Density
Errors: None
4.3.10 SOURce:PULSe:AVAilable? Command
Syntax: SOURce:PULSe:AVAilable?
Parameters: None
Description: Queries the list of available pulse width for current range/resolution settings.
Example: sour:puls:ava? --- 10,20,50,100<END>
Response: List of available pulse width in nanoseconds (NS).
Errors: None
To Next Page
Loading...