Anritsu MT9083 Series - Page 65

4.3 SOURce Subsystem Commands
4-13
4
OTDR Commands
4.3.14 SOURce:PULSe:ENHanced Command
Syntax: SOURce:PULSe:ENHanced<wsp><value>
Parameters: <value>
Boolean format
Range: 1|0.
Description: Set current pulse width’s enhanced mode.
Example: sour:puls:enh 0
Response: None
Errors:
(–200, "std_execGen, Test is Active")
(–104, "std_wrongParamType, Data Type Error")
(–224, "std_illegalParmValue, Invalid Parameter Value")
4.3.15 SOURce:PULSe:ENHanced? Command
Syntax: SOURce:PULSe:ENHanced?
Parameters: None
Description: Query current pulse width’s enhanced mode flag.
Example: sour:puls:enh? --- 1<END>
Response: Boolean value of the enhanced mode flag
Errors: None
4.3.16 SOURce:AVERages:TIMe? Command
Syntax: SOURce:AVERages:TIMe?
Parameters: None
Description: Queries number of seconds that have been set for the next test in manual mode.
Example: sour:aver:tim? --- 120<END>
Response: Number of seconds set to run the test.
Errors: None
4.3.17 SOURce:AVERages:TIMe Command
Syntax: SOURce:AVERages:TIMe<wsp><value>
Parameters: <value>
Integer format
Range: 1 – 3600.
Description: Sets number of seconds for the test duration for the next test in manual mode.
Example: sour:aver:tim 120<END>
Response: None
Errors: (–200, "std_execGen, Test is Active")
(–224, "std_illegalParmValue, Invalid Parameter Value")