Anritsu Sire Master S331D - Page 6

Chapter 3
Getting Started
Introduction ..................................3-1
Power On Procedure .............................3-1
Cable and Antenna Analyzer Mode ......................3-2
All Modes...................................3-10
Save and Recall a Setup ..........................3-10
Save and Recall a Display .........................3-10
Changing the Units .............................3-11
Changing the Language...........................3-11
Adjusting Markers .............................3-11
Adjusting Limits ..............................3-12
Adjusting the Display Brightness......................3-13
Printing ....................................3-14
Using the Soft Carrying Case.........................3-15
Chapter 4
Cable and Antenna
Analyzer Measurements
Introduction ..................................4-1
Line Sweep Fundamentals ...........................4-1
CW Mode/RF Immunity ...........................4-3
Information Required for a Line Sweep ...................4-3
Typical Line Sweep Test Procedures ....................4-3
Chapter 5
Power Monitor Mode
Introduction ..................................5-1
Power Measurement ..............................5-1
Chapter 6
High Accuracy Power Meter
Introduction ..................................6-1
Units and Relative Power ..........................6-1
Limit Lines ..................................6-1
Connecting the Sensor ............................6-1
Zeroing the Sensor ..............................6-2
Using Attenuators ..............................6-2
Power Measurement ..............................6-2
ii