1-3 Recommended Test Equipment General Information
1-2 PN: 10580-00323 Rev. B S331L MM
1-3 Recommended Test Equipment
The following test equipment is recommended for use in testing and maintaining the S331L. Table 1-1 is a list
of test equipment that is required for verifying the S331L Cable and Antenna Analyzer.
Table 1-1. Test Equipment Required for Cable and Antenna Analyzer Verification and Calibration
Instrument Critical Specification Recommended Manufacturer/Model
Frequency Counter Frequency: 2 GHz Anritsu Model MF2412B
Open/Short Frequency: DC to 18 GHz Anritsu Model 22N50
Precision Load Frequency: DC to 18 GHz
Return Loss: 40 dB min.
Anritsu Model SM/PL-1
6 dB Offset Termination Frequency: DC to 4.0 GHz Anritsu Model SC5905
20 dB Offset Termination Frequency: DC to 4.0 GHz Anritsu Model SC5906
Synthesized Signal Source Frequency: 0.1 Hz to 6 GHz
Power Output to +13 dBm
Anritsu Model MG3692B with
options 2, 3, 4, 22, 15
Power Meter Power Range: − 70 dBm to +20 dBm Anritsu Single Channel Model ML2437A
Power Sensor Frequency: 100 kHz to 18 GHz
Power Range: –55 dBm to +20 dB
Anritsu Model SC7400
Power Splitter Frequency: DC to 18 GHz Aeroflex/Weinschel Model 1870A
RF Coaxial Cable Frequency: DC to 18 GHz
N(m) to N(m), 50 ohm
Anritsu Model 15NN50-0.6B
RF Coaxial Cable Frequency: DC to 18 GHz N(m) to N(f),
50 ohm
Anritsu Model 15NNF50-0.6B
To Next Page
Loading...
Need help?
General
