EasyManua.ls Logo

Anslut 004809 - Drainage via Bottom Drain Plug; Maintenance; Cleaning the Air Filter; Cleaning the Appliance

Anslut 004809
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
47
DRAINAGE VIA BOTTOM DRAIN PLUG
When the water level in the collector trough
reaches the specied level the appliance gives 8
audio prompts and the display shows P1. The air
conditioning/dehumidication stops, but the fan
continues to run. Carefully move the appliance
to a suitable drain, remove the bottom plug and
allow the water to run out. Replace the bottom
drain plug and start the appliance. P1 disappears
from the display.
FIG. 22
IMPORTANT:
Remember to rmly replace the bottom drain
plug before starting the appliance to avoid
leakage.
MAINTENANCE
NOTE:
Pull out the plug before cleaning and/or
maintenance.
Do not use ammable chemicals for
cleaning.
Do not pour water on the appliance – risk
of electric shock.
Do not use the appliance if electrical parts
have been exposed to water. A damaged
cord or plug must be replaced by an
authorised service centre or qualied
person to ensure safe use.
CLEANING THE AIR FILTER
IMPORTANT:
Never use the appliance without a lter – dust
and impurities will reduce the performance of
the appliance.
1. Remove the lter from the back of the
appliance.
FIG. 23
2. Clean the lter every other week. Replace
the lter when necessary.
MAINTENANCE
Empty the tank as soon as the warning
code P1 is shown. Always empty the tank
before putting away, otherwise there is a
risk of mould accumulating.
If there are any pets in the house, clean the
grille regularly from hairs that can block the
ow of air.
Cleaning the appliance
Clean the appliance with a soft cloth moistened
with a mild detergent. Wipe with a dry, lint-free
cloth afterwards.
Storage
Empty the tank according to the
instructions.
Allow the appliance to run in FAN mode for
12 hours in a warm room to dry the inside
and to reduce the risk of mildew.
Switch o the appliance and pull out the
plug.
Clean the air lter according to the
instructions, allow to dry and replace.
Remove the batteries from the remote
control.
Store in a dry and cool place. Do not expose
the appliance to heat or direct sunlight, this
can reduce the service-life of the appliance.

Related product manuals