46
2023_001
6 Go back to the application. The product will connect
to the Wi-Fi.
4.4 To disconnect the product from
the Wi-Fi
Push and hold the timer button to disconnect the product
from the Wi-Fi. The Wi-Fi indicator light goes out when the
product is disconnected.
5 Maintenance
5.1 To drain the product
The water produced by the product must be removed. The
water can be removed manually, see “5.1.1 To empty the
water tank manually” on page 46, or continuously, see
“3.1.1 To install continuous drainage” on page 44.
5.1.1 To empty the water tank manually
When the water tank is full, the product makes a sound and
the water tank full indicator lights up.
(Figure 5)
1 Push the power button to stop the operation of the
product.
2 Pull the water tank out from the product.
3 Pour the water out of the water tank.
4 Clean the inside and the outside of the water tank.
5 Attach the water tank to the product.
6 Press the power button to start the product.
Note! If the water full indicator light do not goes out, check
that the float is correctly in place.
5.2 To clean the air filter
Caution! Do not operate the product without the air
filter.
The air filter of the product needs to be cleaned every two
weeks. Dust that is collected in the filter will restricts the
airflow and reduce the eiciency of the system. Blockage in
the air filter can cause damage to the product.
(Figure 6)
1 Remove the filter frame of the product.
2 Remove the air filter from the filter frame.
3 Soak the filter frame in water with a temperature of
about 40C.
4 Rinse the filter frame with a neutral detergent.
5 Vacuum the air filter gently with the brush of a
vacuum cleaner.
6 Attach the air filter to the filter frame.
7 Attach the filter frame to the product.
6 Storage
Caution! Do not store the product in direct sunlight
or rain.
Warning! The product must be stored in a well-venti-
lated area with a floor area of at least 4 m.
Warning! Do not store the product in rooms with
open flames (for example an operating gas appliance) and
ignition sources (for example an operating electric heater).
Warning! The product must be kept in an upright
position when it is stored.
Store the product indoors in a ventilated, dry, non-corrosive
environment.
6.1 To do before the product is stored
Clean the product and dry it out completely, if the product
will not be used for more than a few weeks.
1 Push the power button to stop the operation of the
product.
2 Drain the water tank.
3 Clean the filter frame and the air filter. See “5.2 To
clean the air filter” on page 46
4 Let the air filter dry completely in a shaded place.
5 Collect the power cord.
6 Attach the filter to the filter frame.
7 Attach the filter frame to the product.
To Next Page
Loading...
