Anthem STR User Manual

15
AUTO OFF
:KHQWKHUHLVQRLQSXWVLJQDOWKHXQLWZLOOWXUQR΍DIWHUWKHVHOHFWHGWLPHRUPLQXWHVRUKRXUVRU1HYHU
STANDBY IP CONTROL
When disabled, the unit goes into a low-consumption standby mode and does not sense IP commands. To make it
UHVSRQGWRDSRZHURQFRPPDQGHQDEOHWKLVVHWWLQJ7KLVFDQDOVREHXVHGZLWK56FRQWUROWRDYRLGVHQGLQJD
wake-up command.
3.9 GENERAL CONFIGURATION
This menu contains power saving and control options.
3.10 SAVE/LOAD SETTINGS
SAVE/LOAD USER AND INSTALLER SETTINGS
$IWHUVHOHFWLQJ6DYH8VHU6HWWLQJVDQGFRQȴUPLQJDOOPHQXVHWWLQJVZLOOEHVWRUHGΖI\RXFKDQJHVHWWLQJVODWHUDQGZDQWWR
UHFDOOWKHVDYHGVHWWLQJVVHOHFW/RDG8VHU6HWWLQJVDQGFRQȴUP7KHVDPHDSSOLHVWRVDYLQJDQGUHFDOOLQJLQVWDOOHUVHWWLQJV
RESET ON-THE-FLY SETTINGS
$IWHUVHOHFWLQJDQGFRQȴUPLQJDOOQRQPHQXVHWWLQJVVXFKDVOHYHODQGEDVVWUHEOHZLOOEHUHVHW
LOAD DEFAULTS
$IWHUVHOHFWLQJDQGFRQȴUPLQJDOOPHQXVHWWLQJVZLOOEHUHVHW
FACTORY RESET
Use this only as a last resort if the unit becomes inoperable. Disconnect the power cord and re-connect it while holding
the front panel power button. Do not let go of the button until something appears on the display. The unit will revert to the
software it was manufactured with and all settings will be reset.
*HQHUDO&RQȴJXUDWLRQ
$XWR2II 0LQXWHV
Standby IP Off
Save / Load Settings
Save User Settings
Save Installer Settings
Load User Settings
Load Installer Settings
Reset On-The-Fly Settings
Load Defaults

Anthem STR Specifications

General

Room Correction	ARC (Anthem Room Correction)
Input Impedance	10 kOhms
Power Output (8 ohms)	200W
Power Output (4 ohms)	400 W per channel
Inputs	2 x Coaxial, 3 x Optical, USB
Outputs	Speaker terminals
DAC	32-bit
Weight	40 lbs