Anthem STR - ADVANCED SUBWOOFER TARGETS AND REPORTING; Advanced Subwoofer Target Settings

26
4.7 ADVANCED SUBWOOFER TARGETS
Use of these controls is recommended only for the advanced user who understands the subwoofer’s capabilities and
behavior when fed low frequencies at high levels. As always, check whether changes are worthwhile by listening to a variety
of source material before and after modifying targets.
SUBWOOFER HIGH PASS ORDER
&KDQJHWKHORZHQGVORSHRQO\LIIRUVRPHUHDVRQWKHDXWRGHWHFWHGRQHGRHVQȇWPDWFKWKHORZHQGUROOR΍RIWKH
measured response. The left side of the red or purple measured curve is the guideline for shaping the target curve. As
mentioned earlier, an attempt to use this as a means of extending low-frequency output beyond the speaker’s capability
will be detrimental.
SUBWOOFER HIGH PASS FREQUENCY
Use this in conjunction with High Pass Order when manually creating a curve for the lower end of the subwoofer’s response.
MINIMUM SUBWOOFER EQ FREQUENCY
Change this only if you would not like for ARC to equalize the subwoofer channel below a certain frequency.
4.8 PRINTING A REPORT
To print a copy of your graphs and targets, click on Print. For a preview, click on File then Print Preview.