Left-hand button (4).
With instrument removed
• Short press: enables/disables the spray function.
• Long press (at least 2 seconds): sends a jet of air to the instruments
(chip air); the jet stops when the button is released.
The control works only when the Turbine and Micromotor are
in working position.
”
With instruments at rest
• Long press (at least 2 seconds): calls up the patient rinse position.
Pressing the button a second time returns dental chair back
into working position.
• A short sound warns of the switching.
When the LED (6) is on, it indicates operation WITH spray.
Right-hand button (5).
With instrument removed
• Long press (at least 2 seconds): sends a jet of water to the instruments
(Turbine, Micromotor and Scaler) (Water Clean System function); the jet
stops when the button is released.
• Short press: enables/disables the spray function.
With instruments at rest
• Long press (at least 2 seconds): calls up the reset position.
• A short sound warns of the switching.
When the LED (6) is on, it indicates operation WITH
spray.
WIRELESS version.
This foot control can also be supplied in WIRELESS version (see "WIRELESS foot control" paragraph).
Protection against liquid penetration.
The foot control is protected against liquid penetration. Degree of protection: IPX1.
Cleaning.
Clean the foot control using a suitable product (see Paragraph 1.5).
If the foot control slips on the floor, remove any dust from the slip-proof rubber found under the base with a moist cloth.
To Next Page
Loading...
