Antunes Chick-fil-A RT-2 - Installation

5
P/N 1011309 Rev. B 04/17
INSTALLATION
NOTE: When placing the toaster
into service, make sure to
provide at least 3 inches of
space on all sides of the unit.
1. Remove unit and all pack-
ing materials from shipping
carton. The toaster is shipped
with the items listed below:
• Owner’s Manual
• Authorized Service Agency
Directory
NOTE: If any parts are missing or
damaged, contact Antunes
Customer Service IMMEDIATELY
at +1-877-392-7856.
2. Remove all packing materi-
als and protective cover-
ings from the unit.
3. Refer to Figure 1. Crumb Tray
and the Bun Chute. Wash these
items at the 3 compartment
sink and set aside to air dry
4. Wipe all surfaces of the unit
with a hot damp cloth.
NOTE: Do NOT use a dripping wet
cloth. Wring out before use.
5. Re-install the Crumb
Tray and Bun Chute.
When placing the unit into service, pay
attention to the following guidelines.
y Make sure to provide at least 3
inches of space on both sides of
the unit and at least 6 inches from
the rear of the unit and the wall.
y Make sure the power switch
is o and the unit is at room
temperature before plug-
ging in the power cord.
y Do not block or cover any
openings on the unit.
y Do not immerse the power
cord or plug in water.
y Keep the power cord away
from heated surfaces.
y Do not allow the power
cord to hang over edge
of table or counter.
NOTE: The main Control Panel is
located on the front of the unit.
Figure 1
Figure 2
CRUMB TRAY
BUN CHUTE
CRUMB TRAY
REFLECTOR