How to fix Antunes InfiniSteam IS-1000 LCD Drawer when steamer does not heat?
If your Antunes LCD Drawer steamer isn't heating, first ensure it's properly plugged in and that the circuit breaker hasn't tripped. Next, check that both cavity drawers are fully pushed in. Finally, inspect the pressure switch, control board, contactor, and cartridge heaters for loose connections or continuity issues.
What to do if excessive water is pouring out of the Antunes LCD Drawer cavity?
If you notice excessive water pouring out of the Antunes LCD Drawer steamer, start by removing both drawers and cleaning the drain screens. Also, ensure the drain hose isn't kinked and that a 2" air gap is maintained to the floor drain or drain box. Check the water fill solenoids and steam solenoid valves for any debris.
How to stop excessive steam escaping from the Antunes LCD Drawer cavity?
If you observe excessive steam escaping from the cavity of your Antunes LCD Drawer, begin by removing both drawers of the steamer and cleaning the drain screens. Additionally, confirm that the drain hose isn't kinked and a 2” air gap is maintained to the floor drain or drain box.
What to do if Antunes LCD Drawer steamer continually drains and doesn’t build pressure?
If your Antunes LCD Drawer steamer is continually draining and not building pressure or temperature, turn the steamer off and run a clean cycle. If the problem persists, clean or replace the drain valve with the steamer powered down, and then run a clean cycle.
What to do if water is escaping from the rear of Antunes InfiniSteam IS-1000 LCD Drawer during initial operation?
Check the inlet water feed hose to the Antunes LCD Drawer steamer. Reconnect or replace if necessary. If water is coming from the vent overflow port on the rear panel, contact an Authorized Service Representative.
What to do if system error is displayed on GUI of Antunes InfiniSteam IS-1000 LCD Drawer?
Turn the Antunes LCD Drawer steamer off and then back on. If the error persists, contact an Authorized Service Representative.
General| Model | InfiniSteam IS-1000 |
|---|---|
| Category | LCD Drawer |
| Manufacturer | Antunes |
| Control Type | Digital |
| Material | Stainless Steel |
Read and understand all instructions before installing or using the unit. Must be installed by qualified personnel.
Covers safe operation practices, avoiding damage, and environmental considerations.
Guidelines for cleaning, avoiding damage to finish, and chemical use.
Procedures for inspection, testing, and repair by qualified personnel.
Provides physical measurements, voltage, wattage, amperage, and frequency requirements.
Outlines water quality parameters, pressure, usage, and inlet connection types.
Details crucial water quality, pressure, flow rate, and connection requirements.
Advises on electrical grounding and compliance with electrical codes.
Instructions for safely stacking two units, including securing them.
Step-by-step guide to powering on the unit and its initial procedures.
Explanation of the various icons displayed on the unit's interface.
Guide on manually controlling steaming cycles, including resting and done states.
Procedure for modifying pre-programmed cooking recipes.
Instructions on how to adjust various operational parameters.
Explicit warning against modifying PID controller settings.
To Next Page