Replacement Parts
Parts list (see Exploded diagrams below)
Note
Use only genuine Antunes replacement parts in this unit.
Use of parts other than those supplied by the manufacturer
will void the warranty.
Item
No.
Part # Description QTY.
1 0012982
Conveyor Belt Assembly
37/2
2
2 0013412
Inner Spring Tensioner
Assy
4
3 0021951
Tensioner Bracket
Weldment - Right
2
4 0021952
Tensioner Bracket
Weldment - Left
1
5 0021959 Cam Weldment 2
6 0024413 Conveyor Cover Weldment 1
7 0022040 Bun Chute Weldment 1
8 0022194 End Hsg Weldment 1
9 0022195 Control Housing Weldment 1
10 0022295 Base Weldment 1
11 7001262 Bun Feeder Kit 1
12 0022297
Weldment, Slide Shield -
Crown
2
13 0022298
Weldment, Slide Shield -
Heel
2
15 0022300
Weldment , Conveyor
Cover Rear
1
16 0100295 Platen, Grill 200V/1900W 1
17 0400138 Lock-Nut, Conduit-1/2” Npt 1
18 0400265 Bushing, Shorty 3/8” 4
19 0400315
Strain Relief-Cord
Connector
1
20 0400432 Bushing, Open/Closed 1
21 0502199 Spacer 2
22 0503495 Bracket, Retainer Right 2
23 0503497 Bracket, Tensioner-Left 1
24 0503507 Bracket, Retainer Left 2
25 0504321
Spacer 0.503 X 0.69 X
0.06”
1
27 0506755 Retainer, Bearing 5
29 0507500 Retainer, Bearing 1
30 0507507 Panel, Control 1
31 0600179
Spring, Compression
Setting
2
32 0507509 Aux. Heater Retainer Clip 2
34 0507556 Panel, Electrical 1
35 0507557 Bracket, Contactor 1
36 0507558 Bracket, Thermocouple 1
Item
No.
Part # Description QTY.
37 0507559 Chain Tensioner Bracket 1
38 0507560 Motor Mounting Bracket 1
39 0600143
Spring, Compression
Setting
1
40 0800455 Rod, Knob (Heel) 1
41 0800457 Rod, Knob (Crown) 1
42 0800458 Rod, Support 4
43 0800459 Rod, Bun Feeder 1
44 0800460 Shaft, Drive 2
45 0800900 Rod, Pivot, 3/16 O.D 2
46 1000900 Label - Warning 1
47 1001181 Label, Crown 2
48 1001551 Label, Install 1
49 1001552 Label, Cam (Heel) 1
50 1001556 Label, Wiring Diagram 1
51 1002654 Label, Crown Compression 1
52 1002655 Label, Control 1
53 1031215 Spec Label 1
54 1070013 QR Label 1
56 2100230
Bumper, Recess W/
Washer
4
57 2100378 Rail, Slide 4
58 2100393 Rail, Slide 2
59 2110127 Ring, Retaining 4
60 2120210
Spacer 0.503 X 0.690 X
0.532
1
61 2150179 Sprocket, 25B14 1/2” Bore 1
62 2150187 Chain, Drive 1
63 2150190
Sprocket, 25B28 1/2”Bore
Stepped Tooth
8
64 2150212 Sprocket, 25B12 1/2” Bore 1
66 2150250 Bearing, Flanged 1
67 2150251 Sprocket, 25B14 3/8” Bore 1
68 2150260 Bearing Sleeve 6
69 2150368
Miter Gear, 20° Pressure
Angle
4
70 2150401 Chain, Drive (64 Links) 1
71 2150413 Sprocket, 25B20 1/2” Bore 2
72 2150414 Shaft, Idler 1
73 2150415 Coupler 1
74 2150418 Sprocket, 25B16 3/8” Bore 1
77 2180145 Cover, Bumper 4
78 300P124* Ring, Retaining 3/8” 1
79 303K115* Cotter Pin-1/16” 1
80 303P133* Pin, Clevis 1
81 304P105* Nut, Hex ‘Keps’ #4-40 1
82 306P102* Washer, Int. Tooth #6 1
P/N 1011376 Rev. D 11/20
13
To Next Page
Loading...
