Anybus Wireless Bolt

AT Commands 15 (88)
3.3.10 AT*BSM Security Mode
AT*BSM=
Set the security mode to use for BT. For default value see AT*AMDEFAULT.
Syntax:
AT*BSM=<security_mode>,<store>
Input Parameters:
Name
Type Description
security_mode Integer The security mode to set.
1 = Security disabled, No encryption or authentication.
2 = Fixed pin, Encrypted connection with PIN code security. This
mode only works between two units of this type and brand (Not with
third-party devices, Use Just works in that case). PIN codes must
consist of 4 to 6 digits.
3 = Just works, Encrypted connection without PIN code.
Note: For Bluetooth LE only 1 = Security Disabled and 3 = Just
Works is supported.
store Boolean If store is 1 the new value is stored permanently.
AT*BSM?
Get the security mode used for BT. See AT*BSM= for values.
Syntax:
AT*BSM?
Example:
Input: AT*BSM?
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide SCM-1202-004 EN 1.7