Anybus Wireless Bolt - Advanced Settings

AT Commands 16 (88)
3.3.11 AT*BBM BT Bridge Mode
AT*BBM=
Set the bridge mode for BT. For default value see AT*AMDEFAULT.
Syntax:
AT*BBM=<mode>,<store>
Input Parameters:
Name
Type Description
mode Integer The bridge mode to set.
1 = Bridge mode disabled.
2 = IP forward. (Needed if Bluetooth connection to an android device.
You also need an active DCHP server to be able to connect to an
android device.)
store Boolean If store is 1 the new value is stored permanently.
AT*BBM?
Get the bridge mode used for BT. See AT*BBM= for values.
Syntax:
AT*BBM?
Example:
Input: AT*BBM?
3.3.12 AT*BBD Bonded Devices
AT*BBD?
Get the bonded devices. Note: This also applies to Bluetooth LE.
Syntax:
AT*BBD?
Output Parameters:
Name
Type Description
bd_addr String Bluetooth address of the bonded device.
is_le_device Boolean 0: BT Classic Device
1: BT LE Device
Example:
AT*BBD?<br>*BBD:<bd_addr1>,<is_le_device1><br>*BBD:<bd_addr2>,<is_le_
device2><br>...<br>OK
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide SCM-1202-004 EN 1.7