Anybus Wireless Bolt Reference Guide

AT Commands 33 (88)
3.4.5 AT*WMIMO WLAN MIMO
AT*WMIMO=
Configures which antennas should be enabled 1: Enable only primary antenna 2: Enable both
antennas NOTE: This value is ignored on devices with only one antenna.
Syntax:
AT*WMIMO=<mode>
Input Parameters:
Name
Type Description
mode Integer Configures which antennas should be enabled.
Requires a reboot for the changes to take effect.
Example:
Input: AT*WMIMO=2 enable WLAN MIMO.
AT*WMIMO?
Get WLAN MIMO, MIMO off (1) or MIMO on (2)
Syntax:
AT*WMIMO?
Example:
AT*WMIMO?<br>*WMIMO:<mode>
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide SCM-1202-004 EN 1.7

Anybus Wireless Bolt Specifications

General

Brand	Anybus
Model	Wireless Bolt
Category	Network Hardware
Language	English