Anybus Wireless Bolt Reference Guide

AT Commands 34 (88)
3.4.6 AT*WWM WLAN World Mode
When WLAN World Mode is enabled only frequencies accepted all over the world is used.
When disabled local frequencies can be used but then the device must search for location
during startup which will increase the startup time. New channels must be added manually with
AT*WSCHL.
AT*WWM=
Configures WLAN World Mode 0: Disable WLAN World Mode 1: Enable WLAN World Mode
NOTE: When WLAN World Mode is disabled the startup time will increase.
Syntax:
AT*WWM=<wlan_world_mode>
Input Parameters:
Name
Type Description
wlan_world_mode Integer Enable/disable WLAN World Mode.
Requires a reboot for the changes to take effect.
Example:
Input: AT*WWM=0 disable WLAN World Mode.
AT*WWM?
Get WLAN World Mode, World Mode off (0) or World Mode on (1)
Syntax:
AT*WWM?
Example:
AT*WWM?<br>*WWM:<mode>
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide SCM-1202-004 EN 1.7

Anybus Wireless Bolt Specifications

General

Brand	Anybus
Model	Wireless Bolt
Category	Network Hardware
Language	English