Anybus Wireless Bolt Reference Guide

AT Commands 52 (88)
3.8.5 AT*AMESS Event and Status Subscriber
AT*AMESS=
Set event and status subscriber configuration
Syntax:
AT*AMESS=<mac_addr>,<eth_type>,<ip_addr>,<udp_
port>,<protocol>,<store>
Input Parameters:
Name
Type Description
mac_addr String MAC address of event subscriber. Only used when protocol bit 1 is
set
eth_type Integer The 16 bit Ethernet type to use. Only used when protocol bit 1 is set
ip_addr String IP address of event subscriber. Only used when protocol bit 2 is set
udp_port Integer The UDP port to use. Only used when protocol bit 2 is set
protocol Integer The protocol to use for sending events.
Bit 0: Send events over TCP AT connections
Bit 1: Send events over Layer-2 (mac_address must be specified)
Bit 2: Send events over Syslog
store
Boolean If store is 1 the new value is stored permanently.
AT*AMESS?
Read current event subscriber settings
Syntax:
AT*AMESS?
Example:
AT*AMESS?<br>*AMESS:
3.8.6 AT*AMEECM Execute Easy Configuration Mode
Executes the specified Easy Configuration Mode
AT*AMEECM=
Executes the supplied Easy Configuration Mode.
Syntax:
AT*AMEECM=<mode>
Input Parameters:
Name
Type Description
mode Integer The mode number to execute.
Example:
AT*AMEECM=3<br>OK
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide SCM-1202-004 EN 1.7

Anybus Wireless Bolt Specifications

General

Brand	Anybus
Model	Wireless Bolt
Category	Network Hardware
Language	English