AnyCubic MEGA ZERO - Installation

Installation
1. Installation section contains: @Install the frame @wWiring
2. Be cautions during assembly as some parts may have sharp edges.
3. Itis suggested to use a flat desktop and place the parts in an
orderly manner for quick assembly.
4. The color of some parts may be different from what in the manual,
but the assembly is the same.
5. Firmware has been pre-uploaded to the motherboard. After
completing the assembly, please level the platform and load the
filament then you could start the first test print.
Please note: every units of the printer have been inspected and tested
for printing. Therefore, in some cases, there might be very small marks
left on the print head or on the heated bed. Those will not affect the
printing quality and those means the printer has been tested for the
quality. The aluminum beams are slightly scratched or the platform is
slightly uneven, which is normal under the condition that it does not
affect the normal printing. Thank you very much for your kind
understanding.
Team ANYCUBIC