AnyCubic MEGA ZERO - Resume from Outage

Resume from outage
During printing, if there is an accident power loss, the print will stop
immediately. But after power comes back, customers could “Resume
print” , machine will home first and continuing on the unfinished object.
Power-Loss Recovery
Resume print
Stop print
Note:
fo)
1)
“Resume from outage” is valid only for offline printing.
In slicing software (i.e. Cura), it is required to place the model at
the rear of the platform. Because during “RESUME”, machine will
home first and could touch/interfere with the unfinished object if
the model was placed in the front area.
In order to get smooth surface, use tweezers to carefully remove
the excessive filament at nozzle before continuing print upon the
last point.
Do not move the model after power off otherwise resume will be
invalid.
This function is developed based on Cura. We could not guarantee
this function compatible with other slicing software.
Due to the differences of models, filaments, temperature, extrusion
settings, etc...we could not always guarantee a perfect surface
finish at the point of “RESUME”, especially for small objects.