AnyCubic MEGA ZERO - Page 3

Safety instruction
Always follow the safety instructions during assembly and usage, to
avoid any unnecessary damage to the machine or individual injury
Please contact our customer service first if you have any issue
after receiving the products.
Be cautious when using the scraper. Never direct the scraper
towards your hand.
In case of emergency, please immediately cut off the power of
ANYCUBIC 3D printer and contact the technical support.
ANYCUBIC 3D printer includes moving parts that can cause injury.
It is recommended to wear protection glasses when printed
models to avoid small particles contacting eyes.
Keep the ANycueic¢ 3D printer and its accessories out of the reach
of children.
A
&
O
A
Vapors or fumes may be irritating at operating temperature.
Always use the ANnvcupic 3D printer in an open and well
ventilated area.
ay ANYCUBIC 3D printer must not be exposed to water or rain.
ANYCUBIG 3D printer is designed to be used within ambient
Qh temperature ranging 8°C-40°C, and humidity ranging 20%-50%.
Working outside those limits may result in low quality printing.
Do not disassemble anvcupic 3D printer, please contact
ott technical support if you have any question.