AnyTone BT01 User Manual

9
OFF No Function
Volt Check the current battery capacity voltage
Tx Power
Switch the power between super high, high, middle
and low power.
TalkAround Switch between Talk Around and Repeater mode
Reverse Turn on/off the frequency reverse function.
Digi Encrypt
Choose the digital encryption group for digital
channel
Call
In Analog mode, send the DTMF/5TONE/2TONE
encode. This function is only valid for analog
channel.
VFO / MR
Switch between VFO mode and memory channel
mode.
Scan Scan on/off
AM air/FM Turn on/off AM air band receive or FM radio receive
Alarm
Long press the key to start alarm, short press again
to exit the alarm.
Record Switch Enable/disable the recording function
Record
Start/stop recording. When stop recording, the radio
will remind repeat or send the record.
Messages In digital mode, press to enter into SMS messages
Dial Start the manually dial
GPS Info Check the GPS position information
Monitor
Monitor the weak signal or the signal with
unmatched ID.
Each
[P1]
,
[P2]
,
[P3]
key allows to assign different functions for
short press, long1 press and long2 press.
Short : Function takes effect after click on the button.
Long1: Function takes effect after "du" beep, it needs approx 1.5s
for the press.
Long2: Hold pressing the button until function takes effect, it needs
approx 3s for the press.

AnyTone BT01 Specifications

General

Brand	AnyTone
Model	BT01
Category	Microphone
Language	English