10
Main CH Switch Choose channel A or channel B as the main channel
Hot Key 1~6
Selects Hot Keys 1-6 Note: Hot key setup details on
next page
Work Alone Turn on/off the work alone function.
Nuisance
Delete
During scanning, press the key to skip the unwanted
channel
Digi Monitor
In DMR mode, press the key to turn on/off digital
monitor
Sub CH On/Off Turn on/ off the sub channel
Priority Zone Switch to Priority Zone
Program Scan
Press the key to start the scan in VFO channel scan
start and end frequency must be programmed in
CPS.
Enhanced
Sound
In digital channel, switch the microphone tone to
normal or enhanced mode.
LastCall Reply
In digital channel, press the key to access the last
call and press PTT to call back.
Switch ChType
Switch the channel type(Analog, Digital, Ana+Dgi,
Dgi+Ana)
Ranging
When the radio receives a call and the suspension
time is on, press the key programmed as "Ranging"
to obtain the caller's position and distance. (Both
party need GPS positioned, or will receive only GPS
information)
Roaming
In standby, press the key programmed as "Roaming"
to search and lock on the repeater with strongest
signal. (Note: After lock on a repeater, the radio
will return to last frequency only after channel or
frequency is changed. The repeater frequency list
must pre- programmed in CPS.)
CH Ranging
In standby, if the call contact type for a channel
is "Single call" , press the key programmed as "
Channel Ranging" to turn on this function. The radio
will automatically start ranging function when turn to
this channel.
To Next Page
Loading...
Need help?
General
