11
Max VOL Set
In standby, press the key programmed as" Max
Volume", will enable users to set the maximum RX
volume.
Slot Set
Choose Slot for current channel, this function is only
valid in repeater mode.
Aprs Type
Choose analog or digital Aprs Type for current
channel.
Zone Select
In standby, press the programmed "Zone Select"
key, it will allow you input the zone number and then
press conrm key will switch to the zone.
Roaming Set Enter into Roaming menu quickly
APRS Set Enter into APRS menu quickly
Zone Up Switch the zone upwardly
Zone Dn Switch the zone downwardly
Speaker Mode
Set the voice come out from speaker on microphone
or radio.
Ch.Name
Switch between channel name display and
frequency display for the current channel
GPS On/Off Enable / disable the GPS.
CDT Scan
Enable / disable the CTCSS/DCS scanning for
the analog channel.When the radio nds matched
CTCSS/DCS for current channel, it will open the
speaker and start receiving.
Only the analog channels with CTCSS/DCS
signalling is able to start the CDT scanning.
TBST Send Send the TBST Tone
Aprs Send Manually transmit the APRS at the current channel.
Ana APRS Info Fast access to the anglog APRS info menu
GPS Roaming Enable/disable the GPS roaming function
NoiseReduc(R) Set the noise reduce level for receiving audio
NoiseReduc(T) Set the noise reduce level for transmitting audio
To Next Page
Loading...
Need help?
General
