pg. 5
STEP 2
Figure A
Before drilling any holes for the shower panel brackets, be sure there are no hidden
cables or pipelines aligned with the desired drilling position.
2-1 Drill the two holes for the top bracket 1” apart at the desired height.
2-2 Drill the two holes for the bottom bracket 1” apart below the top bracket.
IMPORTANT
Figure B
2-3 Insert the wall anchors into the pre-drilled holes as shown in Figure B.
2-4 Place the shower panel brackets aligned with the drilled holes and secure the brackets
by tightening the screws.
Figure C
1"
Ø0.24"
Have questions? Call us at 305-614-4070 or visit us at www.ANZZI.com
To Next Page
Loading...
