AOC AG346UCD - Page 28

26
Screen Saver
Off / Slow / Fast
When a static image is detected for a
certain period of time, the screen saver
function will dim the screen to protect
the panel from sticking. When a moving
image is detected, the monitor will recover
luminance to previous working status.
Default setting is Slow and may change as
Fast to active Screen Saver sooner. Would
highly recommend that you always turn
on Screen Saver as Slow or Fast to protect
the screen. It is also recommended that
you also set your device to use a screen
saver.
Logos Protection
Off/1/2
When there are multiple static logos
detected on the screen, it’s suggested
to turn on logos Protection; which will
dim the screen to protect the panel from
image sticking where logos are detected.
Boundary Dimmer
Off/1/2/3
For special aspect ratios that have a black
area in the frame of the screen or a split-
screen, the boundary dimmer feature
can automatically detect and dim the
brightness of specic areas with a large
difference in brightness levels.
Taskbar Dimmer
Off/1/2/3
The Taskbar Dimmer technology will dim
the brightness of the taskbar area on the
screen. No brightness changes will
be noticeable in the areas other than in
the taskbar.
ThermalProtection
Off / On
When the temperature of the monitor
is over 60 degrees Celsius, the Thermal
Protection feature will automatically dim
the brightness of the screen in order
to ensure heat dissipation properly. It
is recommended that you turn on the
feature for the monitor.
Input Select
Auto/ HDMI1/ HDMI2/
DP
Select Input Signal Source
Off Timer 0-24hrs Select DC off time
Image Ratio
Wide /Aspect / 4:3
/1:1 /17”(4:3) / 19”(4:3) /
19”(5:4) / 19”W(16:10) /
21.5”W(16:9) /22”W(16:10)
/ 23”W(16:9) /
23.6”W(16:9) /24”W(16:9)
/27”W (16:9) /30”W (21:9)
/32”W (16:9)
Select image ratio for display.
DDC/CI Yes or No Turn On/Off DDC/CI Support
Reset Yes or No Reset the menu to default
Time after Pixel Re-
fresh
It refers to the time that the screen
lights up after the last Pixel Refresh
operation is executed, in units of hours. A
prompt of executing Pixel Refresh will be
automatically sent to the user every four
hours.
Pixel Refresh
Counts
It is used to record the number of times of
executing Pixel Refresh.