14
English
VGA Mode (Optional)
Problem LED status Remedy
No picture visible Using the OSD menu, adjust brightness and
contrast to maximum or reset to their default
settings.
Check the power switch.
Check if the power cord is properly connected
to the monitor.
Check if the video signal cable is properly
connected at the back of monitor.
Check if the computer system is switched on
and in power saving/standby mode.
Unstable picture
Remain on
Remain on
Remain on
Light off
flicker
Check if the specification of graphics adapter
and monitor is in compliance which may be
causing the input signal frequency mismatch.
Abnormal picture Using the OSD menu, adjust focus, clock,
H-position and V-position with non-standard
signals.
Check the display setting on your system. In
case of a missing image, please select another
resolution or vertical refresh rate.
Wait for a few seconds after adjusting
the size of the image before changing or
disconnecting the signal cable or switching
off the monitor.
Image is missing,
off-center, too large
or too small on the
screen.)
To Previous Page
Loading...
Need help?
General
