ECU-R Installation/User Manual
18
5. Technical Data
Specifications subject to change without notice.
Please ensure you are using the most recent update found at www.APsystems.com.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
802.11b/g/n and 802.15.4
Standard
100~240 VAC, 50~60 Hz 5V 2A
1.7W
122mm×87mmx25mm
150g
-20°C to +65°C
Nature Convection; No Fans
Indoor - NEMA 1(IP20)
Model: ECU-R
REV 1.0
Communication Interface
Integrated Wireless
Antenna
Power Requirements
AC Adapter
Power Consumption
Mechanical Data
Dimensions (W×H×D)
Weight
Ambient Temperature Range
Cooling
Enclosure Environmental Rating
To Next Page
Loading...