Break-in Delay
You may wish to start with the default CW DELAY setting of 300ms. That value gives you plenty of time
to complete words without tripping the T/R circuit at 20WPM. Set the DELAY to a value that best suits
your comfortable operating speed.
QSK
Do not expect fast QSK. At a later time, you can adjust SAMPLE RATE, DSP buffer sizes and DELAY for faster T/R
when you are more familiar with the PowerSDR software. There are good references for QSK at these websites:
http://anan-200D.wikidot.com/
http://www.w1aex.com/anan/anan.html
https://groups.yahoo.com/neo/groups/KC9XG-SDR/info
https://sdrzone.com/
Copyright Apache Labs © ANAN-200D 33 June 22, 2015
To Next Page
Loading...
