Apache Labs ANAN-200D

To Next Page

To Previous Page

Drag Mouse

If you press and hold the left mouse button you can "drag" the frequency of interest into the

panadapter highlighted filter area.

Roll Mouse Wheel – see main window TUNE STEP selections

CTUNE

The PowerSDR "CTUN" button enables "Click Tuning" while using the panadapter and waterfall displays. "Click

tuning" when active, allows you to click within the Panadapter or waterfall to QSY without shifting the

Panadapter or Waterfall display. When "CTUN" is inactive, clicking on the Panadapter re-centers the panadapter,

thereby shifting the entire panadapter. Note that the " CTUN" function only works within a frequency range

equal to the sample rate. IOW, if the selected sample rate is 384khz and RX1 panadapter is 1 MHz, wide, CTUN

will only function within the center 384khz of the panadapter or waterfall display.

DUP

The PowerSDR "DUP" [DUPLEX] button enables RX1 reception during transmit, allowing the user to view the

transmitted RF signal in the Panadapter. The ANAN-200D transceivers switch the selected antenna [ANT1, ANT2,

or ANT3] to ground during transmit, thereby protecting the receiver from damage due to high RF levels.

Monitoring of the RF transmission using the "DUP" feature is visible in the Panadapter and Panafall modes.

LOCK VFO – prevents an unintended change of VFO frequency while in a QSO

Apache Labs ANAN-200D - Page 36