APART PM1122-INT - Settings

PM1122-INT DIGITAL INTERFACE REMOTE
WWW.APART-AUDIO.COM / INFO@APART-AUDIO.COM
MICLVL:  MicrophoneMasterLevel
SELECT:  InputSourceSelection
MINMSC:  MinimumMusicLevel
MAXMSC:  MaximumMusicLevel
MINMIC:  MinimumMicrophoneLevel
MAXMIC:  MaximumMicrophoneLevel
Tobecomplete,thereisalsoa
RSRFFU:  whichhasnofunctionbutisforeseenforfutureuse

Exceptfor“SELECT”,allcontrolscanbeusedwithfollowingcomm ands:SET, GET,INC,DEC.“SELECT”
canonlybeusedwithSETandGET.Aftertheattribute, thezoneneedstobespecified,thiscanbe
ZONE1orZONE2.SETcommandsmustcontainavaluewhichisanumberbetween0and100.For
SELECTthisisA,B,CorD.TheINCandDECcomman dwillincreaseordecreasebyoneifnovalueis
specified.

Settings

Unlessotherwisestated,settingscanonlybeusedwiththeSETcommandandwillonlyhaveONor
OFFaspossiblevalue.

Thefirst3settingsareavailabletoeasetheuseofTerminalsoftwareforconfiguration.

ECHO: Echoofreceivedcharacterscanbeswitchedonoroff.

CR: Repliedstringsareterminatedby“\n”whensettingisoffor“\n\r”(CR+LF)
whensettingison.

BS: Whenon,backspaceechowillclearthe“wrong”characterintheTerminal
window(<BS><SPACE><BS>).

RESPONSE: AnyresponseofthePM1122‐INTcanbedisabledbyswitchingRESPONSEoff.

BAUDRATE: Baudratecanbechanged.OnlySETcommandcanbeused.Possiblevalues
are2400,4800,9600or19200.19200isthedefaultbaudrate.

DBLCLICK: SettingoftheoptionalEasywaveradioreceiver,ifON,doubleclickingthe
volumedownknobontheRFKEYtransmitterwillmutethevolume.

RFKEY: SettingoftheEasywaveradioreceiveronly.



PRESET: Presetscanbestored,recalledandcleared.CommandsareSTR,RCLand
CLR.Withstoreandrecall,firstoptionalparameterisZONE1orZONE2and
thenthepresetnumberbetween1and64.WiththeCLRcommand,theonly
parameteristhepresetnumberthatneedstobeclearedor“ALL”.

VALFB: Ifthissettingison,thePM1122‐INTwill sendastringwheneveracontrolis
changedcontainingthecontrolnameanditsvalue.


6