EasyManuals Logo

APC 600 User Manual

APC 600
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
11
4.0 Installation
4.1 Receiving inspection
Once you remove the UPS from its shipping container, inspect it for dam-
age that may have occurred while in transit. Immediately notify the carrier
and place of purchase if any damage is found. The packing materials are
made from recyclable materials and should be saved for reuse or disposed
of properly.
4.2 Placement
You may install the UPS in any protected environment. The location should
provide adequate air flow around the unit, in an atmosphere free from
excessive dust.
Note: Allow 1-inch (2.5 cm) minimum
clearance on all sides for proper
ventilation.
m amF
m "F©
¦Fd p"=
p§ "F©
F
Fzd "4F"F©
ma mF
m"F©
¦Fdp"=
p§"F©
F
Fzd"4F "F©
4
7
s |¢Q 4h}
Do not operate the UPS in an environment where the ambient temperature
or humidity is outside the limits given in the Specifications section of this
manual (see Sec. 9.6).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the APC 600 and is the answer not in the manual?

APC 600 Specifications

General IconGeneral
Nominal Output Voltage230V
Nominal Input Voltage230V
Output Power Capacity360 Watts / 600 VA
Frequency50/60 Hz
Input ConnectionsIEC 320 C14
Typical Recharge Time6 hours
Battery TypeMaintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof

Related product manuals