EasyManua.ls Logo

APC PX - Page 40

APC PX
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 5 - System Setup
5-4
Installing the Main Intelligence ModuleInstalling the Main Intelligence Module
Installing the Main Intelligence ModuleInstalling the Main Intelligence Module
Installing the Main Intelligence Module
(MIM)(MIM)
(MIM)(MIM)
(MIM)
The main intelligence module is factory installed. The fol-
lowing procedure is provided in the event that the MIM is
removed or replaced:
Note: The main intelligence module is installed in the upper
right bay of the Power Array frame. The main intelligence mod-
ule is always installed in the bottom rack in this bay, and the
redundant intelligence module is always installed in the top rack
in this bay.
1. Carefully align the installation rail on the MIM with the
track that runs along the inside of the bay.
2. Slide the MIM into the bay.
3. Tighten the two retaining screws. Do not overtighten.
4. Swing the flip latch into place, and tighten the screw. Do
not overtighten this screw. See figure 5-9.
Fig 5-10 Location of the MIM and RIM
Redundant
Intelligence
Module
(RIM)
Main
Intelligence
Module
(MIM)
Installing the Redundant IntelligenceInstalling the Redundant Intelligence
Installing the Redundant IntelligenceInstalling the Redundant Intelligence
Installing the Redundant Intelligence
Module (RIM)Module (RIM)
Module (RIM)Module (RIM)
Module (RIM)
The redundant intelligence module is factory installed. The
following procedure is provided in the event that the RIM is
removed or replaced:
Note: The redundant intelligence module is installed in the up-
per right bay of the Power Array frame. The redundant intelli-
gence module is always installed in the top rack in this bay, and
the main intelligence module is always installed in the bottom
rack in this bay.
1. Carefully align the installation rail on the RIM with the
track that runs along the inside of the bay.
2. Slide the RIM into the bay.
3. Tighten the two retaining screws. Do not overtighten.
4. Swing the flip latch into place, and tighten the screw. Do
not overtighten this screw. See figure 5-9.

Related product manuals