set W-Ape to "W-Ape (Reciever)" and connect a 3-pin DMX
cable from the DMX output of the W-Ape to the DMX input
of the light fixture (to wirelessly control a fixture that does
not have wireless DMX built-in, such as a fixture from a
brand other than Ape Labs).
Info
› Battery: During set-up mode, this will display the precise
battery level of each light fixture.
› Serial: This will display the serial number of the fixture.
› Firmware: This will display the firmware version of the fixture.
DMX Mode
› During set-up mode with given fixture, this will let you select
the number of DMX mode for the fixture.
o
Off: W-APE/DMX-Mode is not activated - the device
is only controllable by the remote control
o
3C: 3 channels: Dimmer, Program, Speed
o
4C: 4 channels: Red, Green, Blue, White (each is 1-
DMX channel/8 Bit)
To Next Page
Loading...