› Step 3: Turn on fixture with long press on power button (5
seconds – if done correctly, fixture will blink blue).
› Step 4: Press Right Arrow button to pair remote and light.
› Step 5: Turn light off then back on. It will now only be
controlled with that specific remote.
› Step 6: To unpair, follow steps 1-3, then press Left Arrow
button to unpair.
NOTE: In case you lose paired remote, any remote can be
used to unpair fixtures.Reset or Update of Firmware
Reset or Update of Firmware
Press and hold the power button of the ApeLight Maxi for about
10 seconds. The device will restart and stay in update mode for
To Next Page
Loading...