› Within this period (group LED flashing), you can assign
another group by pressing the “Group” button on the remote
control one more time.
› The ApeStick4 will flash blue for a short time to
acknowledge that.
Note: The remote control switches to a power-save mode after a
few minutes and will not detect the power-on event of an
ApeStick4. Press any key of remote control to stop the power-
save mode.
Using the Remote Control
› To select the group you’d like to control, tap the „Group“
button until the group LED is lit up. To control all groups at
once, press and hold the „Group“ button until all four group
LED’s light up.
› Programs, brightness, speed and sound active mode can be
controlled by the corresponding keys (see figure).
To Next Page
Loading...