13
H
G
IMPORTANT INSTALLATION NOTICE!
The Quick Connect fittings come with end
plugs that need to be removed before the
tubing can be connected. Please disconnect
the end plugs at Points G and H from the
Quick Connect fittings before connecting
tubing. See Fig.10A and
Fig.10B.
Fig.10A
Fig.10B
Step 6: Connecting The System
Fig.10C
Fig.10D
To Disconnect the End Plugs:
Push in and hold down on the collet ring square against the
fitting. While holding down the collet ring, pull out the end
plug with your other hand. Only the plug will slide out from the
connection. See Fig.10C.
Depending on your system model, there will be 2 types of protective end
plugs. Both types of end plugs are disconnected the same way. After
disconnecting the end plugs, please discard them as they are not needed for
installation.
Soft Plug Hard Plug
2 Types of End Plugs
To Connect the Tubing:
Push the tubing all the way into the Quick-
Connect fitting, then gently pull back on the tubing to make sure
the connection is completely secure. See Fig.10D.
- No inserts, sleeve, or nuts are needed to secure the connection.
- No Teflon tape!
To Next Page
Loading...
