18
P3.5. – Adjust time
1. When key is pressed, Hour flashes, then press and Minute
flashes. When the number flashes, press key and key to adjust
time, then press to confirm.
2. After confirming date, press key to enter in P3.6 mode or press
key to return to the measurement mode.
P3.6. – Clear all storage value (No—Yes)
1. When key is pressed, No flashes, then press key to select No
—Yes, press key to confirm. No: not delete, Yes: Delete.
2. After confirming the parameter, press key to enter mode P3.7 or
press key to return to the measurement mode.
P3.7 – Automatic power-off setup (10→20→30→On)
1. Press key, On flashes, press key to select 10→20→30→On,
press key to confirm.
On – turn off automatic power-off, Time unit is minutes.
2. After confirming the parameter, press key to enter P3.8 or press
to return to the measurement mode.
P3.8 – Set automatic lock-up function（Off→On）
1. Press key, OFF flashes, then press key to select OFF→On,
press key to confirm. Off: not set, On: set (the reading is
automatically locked when stabilizes＞10 seconds.)
2. After confirming the parameter, press key to enter measurement
mode.
7
USB Communication
7.1 Software Requirement
The meter uses “PC-Link” software connected to via USB port. The recommended requirement for the
computer are: Personal computer (Microsoft Excel 2000 or the version of higher rank) which can operate
Windows XP operation system, PC – IBM compatible with XT and CD-ROM driver, USB communication
port.
To Next Page
Loading...
Need help?
General
