Aphex Studio Dominator 700 - Tracking; Release Time; Tec; The EO Section

6.3.6 TRACKING-
Causes left and right channel limiters to track
gain reduction band-far-band when "on".
6.3.7 RELEASE TIME -
Adjusts the limiter gain reduction release time.
6.3.8 TEC-
Transient enhancement
acoustically increases
the audio when "on".
circuit which
the transient
psycho-
"feellr of
Most of the above
explanatory. A few words
order, however.
controls are sufficiently self
about equalization and TEC are in
6.4 The EQ Section
When the EQ controls are at 12 o'clock, all the bands are
driven equally from the crossover filters. This results in flat
response through the limiter. A 6dB boost or cut can be
obtained for drive to the low and high band limiters using the
EQ controls. For audio signals below threshold, the
equalization will follow the the EQ settings. However, when the
signals rise into limiting, any EQ boost will be reduced or
eliminated as each band approaches maximum limiting.
6.5 TEC
The TEC circuit restores articulation to the audio by
manipulating the below-threshold audio envelope without
changing the average power content or peak amplitude of the
audio wave. It can be used to bring out more punch in an audio
source, or to improve the dimension and imaging qualities of
the audio. A noticeable increase in the perceived loudness of
the audio is an additional benefit of the TEe process.
Depending on audio source type and quality, the effect of TEe
may be subtle or quite noticeable.
21