Apollo Seiko OMEGA - Page 11

11 / 60
11.3.14 h : Soldering Completion Report
【Code】 ６８Ｈ(‘ｈ’)
【Function】
Soldering completion report
【Direction】
Soldering controller → External controller
【Data】
None
【Explanation】
It returns completion of soldering operation to H command that is from the upper
controller.
I
n case of Slide soldering, This command is not returned.
1
2
3
4
5
STX
‘ｈ’
ETX SUM
11.3.15 I : Slide Soldering Start Request
【Code】 ４９Ｈ(‘Ｉ’)、４ＡＨ(‘Ｊ’)
【Function】 Ｉ： Slide soldering start request
【Direction】
External controller → Soldering controller
【Data】
None
【Explanation】
Refer to “13.2 Slide Soldering Operation” about operation.
1
2
3
4
5
STX
‘Ｉ’
ETX SUM
1
2
3
4
5
STX
‘Ｊ’
ETX SUM
11.3.16 i： Slide Soldering 1st Feeding Completion Report, j: Slide Soldering Pre-heat Completion
Report, k: Slide Soldering Completion Report
【Code】 ６９Ｈ(‘ｉ’)、６ＡＨ(‘ｊ’)、６ＢＨ(‘k’)
【Function】 ｉ： Slide soldering 1st feeding completion report
ｊ： Slide soldering pre-heat completion report
ｋ： Slide soldering completion report
【Direction】
Soldering controller → External controller
【Data】
None
【Explanation】
Refer to “13.2 Slide Soldering Operation” about operation.
1
2
3
4
5
STX
‘
i
’
ETX
SUM
1
2
3
4
5
STX
‘ｊ’
ETX SUM
1
2
3
4
5
STX
‘ｋ’
ETX SUM